Verex Monitor ISM Specifikace stáhnout pdf (Strana 29)

22-9058 v2.1

Welcome PCPanel IP

Cent. Mon. with IP

Ref. Topics

3.5 Security IP Receiver Software (SIP)

(at the Central Monitoring Facility)

3.5.1 Introduction

The IP receiver software polls up to 1000

panel connections (IP boards), and relays

the messages it receives to alarm

automation software (MAS or equiv.) using

the SG-DLR2 protocol.

Each panel is referenced by the ”Digital

Account ID” which is displayed as the account # in the receiver software. This is set through

the system communications screen of the Director software, or with S001:00 through an LCD

keypad.

3.5.2 Connection between the IP Receiver PC and the Automation PC

Connect through an available serial com port (RS-232) using wiring that is compatible with the

automation software. (Tip: The serial com port being used needs to be set in the IP receiver

software as well.)

3.5.3 Connection Mode Options

The IP Receiver software can connect using any of these modes:

• Auto-Mode: (Single-Panel Only). This uses only the IP address and port number of the IP

Interface board. All other settings are taken care of automatically avoiding most common

problems including address duplication etc.

Note

: With this setting, leave the "Connect Number" blank at the IP Receiver software.

•

Main Panel Motherboard Serial Number Mode: (Single panel or shared connection.). This

uses the serial number of the panel, plus the IP address and port number of the IP Interface

board. This is the easiest approach that supports a multi-panel connection.

The panel's Serial Number:

+ Is defined through the Director software under: Configuration⇒System ⇒Communication

(can be viewed through an LCD keypad under S005:00, 1

field) if the Memory Model is less

than ≤ 4.

+ Must be entered as the "Connect Number" through the IP Receiver

software.

• Digital Account ID/Number: (Single-panel or shared connection). This uses the "Digital Account

ID" of the panel, plus the IP address and port number of the IP Interface board.

The digital account number:

+ Must be unique for each panel.

+ Is defined through the Director software under: Configuration⇒System ⇒Communication

(or through an LCD keypad under S001:00 (2

field) if the Memory Model is less than ≤ 4.

+ Must

also be entered as the "Connect Number" through the IP Receiver software,

and as the

"Account Number" through the automation software;

• SIP Address

: (Single-panel or shared connection). This uses the optional panel

setting "SIP Address", plus the IP address and port number of the IP Interface board.

The panel SIP Address:

+ Must be unique for each panel on a shared connection (i.e. on the same IP board)

01 – 80 (00 = not used)

+ Is defined through the Director software under: Configuration ⇒System ⇒Communication

(or through an LCD keypad under S005:02 (2

field) if the Memory Model is less than ≤ 4.

+ Must

also be entered as the "Connect Number" through the IP Receiver software.

Director PC: The Security IP Receiver software cannot

be run on the MONITOR ISM / AFx Director PC. A

separate PC will need to be dedicated

Activation Key: The IP receiver software requires an

activation key on the parallel port of the PC.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Komentáře k této Příručce

Žádné komentáře

Verex Monitor ISM Specifikace Strana 29

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Verex Monitor ISM